MOLECULES CONCHEM PVT. LTD.

MOLEGROUT GP2

Ready-to-use Non-shrink Free Flow Cementitious Grout

DESCRIPTION

MOLEGROUT GP2 is a grout for general purpose and MOLEGROUT GP2 for extra strength. MOLEGROUT GP2 is a ready-to-use free flow cementitious grout in powder form. Only water needs to be added. Such fluid grout will maintain its original volume during hardening.

STANDARDS

It conforms to CRDC (Corps of Engineers’ Specification) 621.

USES

Grouting of machine bases/foundation, column bases/ steel and precast concrete, anchor bolts, holding down bolts. Extra strength grout is used in crane and transporter rail, turbo Generator bases etc.

FEATURES

  • Non-shrink positive surface contact.
  • No rusting, staining on exposed edges- chloride free.
  • Rapid installation and early operation through faster development of strength.
  • Greater durability to installed structure.
  • Simple to use-addition of water only needed.
  • Highly reliable quality – produced under rigid quality control.

APPLICATIONM

All surfaces should be free from dirts, dust, grease, oils, and other contaminants. Surfaces should be prewetted/ saturated with clean water for 4 to 6 hours, free surface water should be removed, before grouting with MOLEGROUT GP2.

MIXING

Add MOLEGROUT GP2 powder to potable water in the ratio recommended for its consistency.

FLOWABLE GROUT

Water/25kg grout bag 4.25 L

PLASTIC GROUT

Water/25kg grout bag 3.25 L Manual mixing is not at all recommended. Use mechanical mixer like paddle or revolving drum type. Full 5 minutes mixing to get homogeneous consistency is required. Fluid grout should be placed within 20/30 minutes. In gelled material no further addition of water is allowed and should be discarded.

PLACEMENT

Pouring head should be used for base plate grouting. For holding down bolt in 10 cm and above diameter hole or grout bed exceeding 80 mm thickness well graded clean aggregate from 5 mm to 15 mm in saturated surface dry condition may be used along with MOLEGROUT upto 25 to 30% of grout weight.

EDGE FINISH/CURING

Plastic MOLEGROUT may be used for edge finish. Exposed edges after 8 hours of grouting should be kept under steel plate up to 24 hours and then normal curing with wet hessian or ponding may be carried out.

STORAGE

  • Keep it in a dry place

SHELF LIFE

  • 6 months

PACKING

In 25 kg poly packs

HEALTH & SAFETY

Non-toxic. Non-flammable for free flow consistency, W/P : 0.16

TYPICAL COMPRESSIVE STRENGTH, KG/CM²

1 day : 250
3 day : 350
7 day : 450
28 day : 600
Yield : 2 kg

MOLEGROUT powder is required to fill 1L cavity. Ecofriendly.

ABOUT US

It is mission with the aim to provide the highest level of satisfaction to our esteemed clients. From more than Five years, Molecules offer a complete range of over speciality chemicals including a range of Adhensives & Sealants,

Adderss

Address:  Behind Maida Mill, Old Hansi Road, Jind (Harayana) 126102

Phone:  +91 90348-90100

Email:  info@moleculesindia.in

Websait:  www.moleculesindia.in

Keep Connected